Isolator switch in the off position, notice the small text around the
switch that labels this side as off
Routine 1: Turning your marker on/off
- Ensure the batter is charged
- Switch the isolator switch to the ON position
- The LED on the rear of the grip frame will be green
- The LCD display will show flash between 'SAFE' and the firing mode (ex: SEMI2)
Isolator switch in the off position, notice
the small text around the
switch that labels this side as off
Isolator switch in the on position, green
light on to indicate safe mode
Startup/boot display
If the trigger is depressed
the Serial Number of the marker will display between SAFE and the 5 digit number
Due to the trigger being depressed on the opto-switch, the marker cannot switch from live to safe or vice-versa. If the marker will not cycle whilst in live mode this is typically the same setup and is due to a shorten TOE point and can be adjusted in routine x